Everything we make, from the same workshop that builds for rescue teams and the Canadian military. Available through select retailers.
13 products across 4 categories
Fourteen years as a side project. Built on twenty years of making harnesses for rope access and rescue. The Aino starts as raw webbing on a roll and leaves as a finished harness, cut, sewn, and assembled entirely in our Fergus workshop. Buckles machined in-house on our CNC. Every unit pull-tested and visually inspected. Field-tested by climbers putting up hard routes in the Canadian Rockies.
Tube-style belay and rappel device. Light enough for an alpine rack.
Mini pulley with aircraft aluminium side plates and needle bearings.
Hot-forged D-shape with keylock nose. Clean alignment, no snagging.
Rope grab with push-pin axle. Gentler on rope than an ascender.
Straight and bent-gate carabiners on a 12cm polyester dogbone. Sewn in Canada.
12cm polyester dogbone with rubber keeper. Sewn in Canada.
Polyester anchor sling, sewn in Canada. Colour-coded by length.
8mm prusik cord sewn with a programmed stitch pattern. Three standard lengths.
Built in Canada from 1000D Cordura. Fits a 50m rope, backpack straps.
Synthetic rubber keepers for 20mm webbing. Pack of 5.
10-piece passive nut set. Classic curved profile, full size range #1–#10.
Goat leather with padded insulation layer. Handles friction heat properly.
70% rayon from bamboo, 30% organic cotton. Unreasonably soft.
No products in this category yet.
Sign up and we'll let you know when these products come to a retailer near you. One email, no spam.
One email when products reach retailers. That's it.
